Maytag Washer Restore Assist, Neptune Washer Troubleshooting and How To Entry

This washer and dryer set has been round for a while now, the 3000 collection might be nearly 12 years previous.

Accessing the washer’s foremost elements is usually finished from the entrance, to take away the again is straightforward, I’ll describe “How To” on the finish of this text Dryer Repair Los Angeles.

Step one in accessing your washer is to take away the screws across the door body. There are two screws situated on the door hinge and two straight reverse. These 4 screws will should be taken out to realize entry into the within of the washer.

With the entrance off the washer, the drain pump, motor management board and several other different elements might be seen and accessible. The motor management on the suitable is understood for going out, in case your washer stopped spinning, provides an LR error code, this motor management is the probably offender. Cleansing the pump could be finished from the entrance or the again, the again panel is held tight with 4 screws. The one trick to getting the again panel again on is to snap the plastic onto the steel earlier than the panel is put in.

If you’re one of many unfortunate ones coping with the wax motor management board malfunction, you aren’t alone, the highest of the washer will should be lifted in an effort to achieve entry.

To take action the 4 screws beneath the cleaning soap dispenser will should be eliminated, these are the screws the arrows are pointing to within the image on high of the washer.

To ensure that the highest raise free the 2 nook brackets will should be eliminated, you probably have already eliminated the screws across the door body and the entrance is off you will notice the 2 brackets that maintain the highest down, one 5/16 screw holds every bracket.

Leave a Reply

Your email address will not be published. Required fields are marked *